New AbMat Logo

Comments

• June 19, 2012 12:01 PM
   amac1990
    Project Holder
  Check out the most recent sketch in .pdf format. The windows of the As and B are enlarged, the M is revised,the "MADE IN THE U.S.A." line is spaced such that there is balance from left to right. The lines of the main logo are extended to connected to the lines around the patent information. The lines should be a little thicker to facilitate ease of screen printing. Also, include a circle R symbol.
  
  0   0
  
• June 15, 2012 3:08 PM
   amac1990
    Project Holder
  Please see the new image I have attached showing a sketched example of what we're looking for. Maybe the logo would look better without the breaks between the extended letters and the line below. Maybe the logo would look better with the patent information located below the line not in reverse.
  
  0   0
  
• June 15, 2012 11:59 AM
   SiteAdmin
   
  Attention Designers, MycroBurst permits you to submit unlimited designs with unlimited variations. However, if you show 2 or 3 different color versions of the same logo in one draft, please make sure that if that draft gets finalized, each color version is separated before final files are sent out. Thanks, MB/LDG Team
  
  0   0
  
• June 15, 2012 6:46 AM
   amac1990
    Project Holder
  #6 is the closest. The "MADE IN THE U.S.A." needs to be more prominent with the Patent Number below it. The Patent Number information needs to be smaller than the "MADE IN THE U.S.A." tagline, and it should be oriented to the right. The curve on the "T" should be extended through the line below. You can try extending the arm "T" through the line below as was done with the leg of the "A" on the other end. Also, you can keep the AbMat part of the logo separate and extend the line below it out to maximize the area where the "MADE IN THE U.S.A." can be put in reverse. For this second version, keep the AbMat part and the line separate, but still continue the curve of the AbMat logo through the line below.
  
  0   0
  
• June 13, 2012 10:42 AM
   amac1990
    Project Holder
  Also, the notches at the bottom of the "M" in #3 are not substantial enough. The legs of the letter need to be more defined.
  
  0   0
  
• June 13, 2012 10:40 AM
   amac1990
    Project Holder
  We want to maintain the base curve of the original logo. The "M" just needs to be refined. #3 is a step in the right direction for that, but the "V" at the top of the "M" needs to be more curved. For the most part, the AbMat part of the new logo does not need to change. We want to see the tagline part in reverse with the patent information smaller and below the "MADE IN THE U.S.A." line, probably located to the right instead of the middle.
  
  0   0